Nortel 1110 Installation And Operation Manual page 364

Page 364 of 630
Before you begin
First-time installation
553-3001-368 Standard 26.00
Nortel IP Phone 1120E
• Configuring the IP Phone 1120E
• Startup sequence
• Installing the IP Phone 1120E
Before installing the IP Phone 1120E, complete the following pre-installation
checklist:
• Ensure there is one IP Phone 1120E boxed package for each
IP Phone 1120E being installed. The package contains:
— IP Phone 1120E
— handset
— handset cord
— 2.1 m (7 ft) CAT5 Ethernet cable
— Number plate and lens
— Getting Started Card
• Ensure there is one Software License for each IP Phone 1120E being
installed.
• Ensure the host Call Server is equipped with the Voice Gateway Media
Card, or a Signaling Server with the Line TPS application.
• If an AC power adapter is required, ensure the approved Nortel global
power supply (model # N0089601) is used. See Table 42, "IP Phone
1120E components list," on page 362
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server:
August 2007
.