Manual Configuration - Nortel 1110 Installation And Operation Manual

Page 592 of 630

Manual configuration

553-3001-368 Standard 26.00
Appendix G: Bluetooth wireless technology
The following methods are available to enable Bluetooth wireless technology
on the IP Phone:
• Manual configuration— can be used to set the Bluetooth wireless
technology mode on the IP Phone on a phone-by-phone basis. If manual
configuration is used exclusively, a TFTP server is not required to
configure Bluetooth wireless technology. For further information about
manual configuration, see "Manual configuration" on page 592.
Use Procedure 124 on
technology through the Local Tools > Network Configuration
submenu.
• TFTP configuration—can be used to initially set the Bluetooth wireless
technology mode then the TFTP Server can be removed. The IP Phone
will now retain the value and will use the last value received if no new
value is received.
Use Procedure 125 on page 594 to enable Bluetooth wireless technology
on the IP Phone 1140E using the TFTP configuration file (1140e.cfg)
retrieved during bootup.
Note: If Bluetooth wireless technology is enabled on your phone, and
password-protection for the Local Tools menu has been enabled, you can
still double-press the Headset key to access the 3. Bluetooth Setup
menu.
You can enable or disable Bluetooth wireless technology through the
Network Configuration menu. The Enable Bluetooth option provides
administration control over Bluetooth wireless technology. The following
values are available:
• Auto—(default) Bluetooth wireless technology setting received through
TFTP configuration
• Yes—Bluetooth wireless technology is enabled on the IP Phone
• No—Bluetooth wireless technology is disabled on the IP Phone
When the IP Phone 1140E firmware is upgraded, or when the IP Phone is
received from the manufacturer with the latest firmware, the default power up
August 2007
page 593 to configure the Bluetooth wireless