Nortel 1110 Installation And Operation Manual page 599

Appendix G: Bluetooth wireless technology
Procedure 126
Pairing the Bluetooth wireless technology headset
with your IP Phone
1 Restart your IP Phone using one of the following methods:
• If you are using an AC power adapter, unplug it, wait ten seconds,
and reinsert it.
• If you are using POE, unplug the LAN Ethernet cable, wait ten
seconds, and reinsert it.
2 Double-press the Headset key to open the 3. Bluetooth Setup dialog box.
The Enable Bluetooth check box is highlighted.
Note: If the 3. Bluetooth Setup menu fails to open when you double press
the Headset key, Bluetooth wireless technology is not enabled on your
phone.
3 Press the Enter key to activate Bluetooth wireless technology.
A check mark is displayed to indicate that Bluetooth wireless technology
is activated. The message BT Enabled appears at the bottom of the
display.
4 Put your wireless headset in its pairing or search mode. The procedure
for doing this can be different for each wireless headset. See the
documentation that accompanied your headset.
5 Search for the headset.
a. Press the Right navigation key twice to highlight the Search button,
displayed next to the Search Devices item.
b. Press the Enter key.
The message Searching... is displayed.
If the search is successful, a list of Bluetooth wireless technology
headsets appears in the Found: combo box.
c. Choose one of the following:
— If the search is successful, proceed to step 6.
— If the search is not successful, the message Search completed.
No device found is displayed. Power off the wireless technology,
and repeat step 4 and step 5.
IP Phones Description, Installation, and Operation
Page 599 of 630