Nortel 1110 Installation And Operation Manual page 327

Table 38
IP Phone 1110 IP parameters (Part 2 of 2)
Parameter
Connect Server (IP address, port,
action and retry count—primary
and secondary)
User ID (Node ID, Node Password
and TN)
Installing the IP Phone 1110
Method of acquisition
Manually entered or automatically obtained through Full
DHCP.
Manually entered for first-time configuration. Obtained
from local storage on subsequent power cycles.
Use Procedure 58 to install the IP Phone 1110 for the first time using manual
configuration. Use Procedure 59 on
the first time using Full DHCP.
Procedure 58
Installing the IP Phone 1110 for the
first time using manual configuration
Timing information for manual configuration
To enter the manual configuration mode, you have approximately
30 seconds (s) between plugging in the IP Phone 1110 power adapter
and the appearance of the text Nortel. When you see the text Nortel on
the phone, you have one s to respond by pressing the four soft keys at
the bottom of the display in sequence from left to right. If you miss the
one-s response time, the IP Phone 1110 attempts to locate the connect
server. You can begin the power-up sequence again, or you can double-
press the Services key to open the Local diagnostic utilities to access
the IP Phone settings. See Appendix Appendix E:: "IP Phone diagnostic
utilities" on page 525.
Note: If you are prompted to enter a password when you double-press
the Services key, password protection is enabled. For more information
about password protection, see "Local Tools menu password protection"
on page 313.
Nortel IP Phone 1110
page 334
IMPORTANT!
IP Phones Description, Installation, and Operation
Page 327 of 630
to install the IP Phone 1110 for