Nortel 1110 Installation And Operation Manual page 484

Page 484 of 630
553-3001-368 Standard 26.00
Expansion Module for IP Phone 1100 series
Figure 51
Adjusting the stand angle on the IP Phone
Accessory Expansion
Module port
2 At the back of the IP Phone, remove the rubber plug from the Accessory
Expansion Module (AEM) port. Place the connecting arm of the
Expansion Module behind the IP Phone and align the Expansion Module
connection plug to the AEM port on the back of the IP Phone.
3 Insert the screws in to the top and bottom holes of the connecting arm of
the Expansion Module and tighten until snug. See Figure 52 on
August 2007
page 485.