Nortel 1110 Installation And Operation Manual page 425

6 Use the Up/Down navigation keys to scroll and highlight one of the
following options:
• 10BT Full—10 BT Full Duplex mode
• 100BT Full—100 BT Full Duplex mode
7 Press Enter to exit the edit mode.
8 Press the Apply&Reset soft key to save the changes and to restart the
IP Phone 1140E. The firmware settings are read and are applied to
UPLINK and the PC Ethernet Port.
When the IP Phone is restarted, the firmware reads the setting for Full Duplex
mode and sets the LAN Ethernet port, PC Ethernet port, duplex, and speed
accordingly.
Use Procedure 75 to confirm activation of Full Duplex mode.
Procedure 75
Checking Ethernet Statistics
1 Double-press the Services key to open the Local Tools menu.
2 Press 2 to select Local Diagnostics, then press 3 to open the Ethernet
Statistics menu.
If Full Duplex mode is active, the following is displayed:
• Link Status: UP
• Duplex Mode: Full
• Network Speed: 10 Mb, 100 Mb or 1G
• Auto Sense/Negotiate
— Auto-Negotiate Capability: No
— Auto-Negotiate Completed: No
Nortel IP Phone 1140E
End of Procedure
End of Procedure
IP Phones Description, Installation, and Operation
Page 425 of 630