Installation And Configuration - Nortel 1110 Installation And Operation Manual

Page 128 of 630
First-time installation
Configuring the IP Phone 2002
553-3001-368 Standard 26.00
Nortel IP Phone 2002
You must first install an IP Telephony Node with the Communication Server.
For information about installing an IP Telephony Node, see Signaling Server:
Installation and Configuration (553-3001-212), or IP Line: Description,
Installation, and Operation (553-3001-365).
CAUTION
Do not plug your IP Phone 2002 into an ISDN
connection. Severe damage can result.
Use Procedure 17 on
time.
Procedure 17
Configuring the IP Phone 2002
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP Line:
Description, Installation, and Operation (553-3001-365), and Software
Input/Output: Administration (553-3001-311).
2 Configure the IP Phone 2002 on the Call Server using LD 11.
For more information, see Software Input/Output: Administration (553-
3001-311).
3 Connect the IP Phone 2002 components:
a. Connect one end of the handset cord to the handset jack on the back
of the IP Phone (identified with a handset icon).
b. Connect the other end of the handset cord to the handset.
4 Choose one of the following connections:
• For an IP Phone not sharing LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the network interface
located on the back of the IP Phone (identified with a LAN icon, see
August 2007
page 128 to configure the IP Phone 2002 for the first