Nortel 1110 Installation And Operation Manual page 67

VLANFILTER (0-No, 1-Yes)
Duplex? (0-Auto, 1-Full)
PSK SRTP? (0 for No, 1 for Yes)
GARP Ignore? (0-No,1-Yes)
Note: You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware. For CS 1000
Release 4.5, accept the default value of 0.0.0.0. For Succession Release
3.0 or CS 1000 Release 4.0, enter the TFTP Server IP address. The
IP Phone searches for the TFTP Server for firmware upgrade. If the file
name specified in configuration file is not the same as the current
firmware, the IP Phone downloads the file and upgrades the firmware.
This takes several minutes. When the upgrade is complete, the IP Phone
reboots. For further information about TFTP Server configuration, see
Appendix Appendix H:: "TFTP Server" on
The IP Phone 2001 can support a primary (S1) and secondary (S2)
connect server. If you require IP Phones to register on multiple nodes,
see "Enhanced Redundancy for IP Line Nodes" in IP Line: Description,
Installation, and Operation (553-3001-365).
The IP Phone 2001 saves the configuration and then reboots. The
IP Phone 2001 searches for the connect server. When the connection is
complete, proceed to step 8.
8 Enter the following information:
Screen prompt
Password
Node
TN
Nortel IP Phone 2001
Default 0 (0 for No)
You are not prompted for
VLANFILTER if VLAN is not
enabled.
Default 0 (for Auto)
Default 0 (for No)
Default 0 (for No)
Description
IP Phone Installer Password
You are not prompted to enter the IP Phone
Installer Password if it has not been
configured in your system.
The node ID
The TN or VTN
IP Phones Description, Installation, and Operation
Page 67 of 630
page 605.