Nortel 1110 Installation And Operation Manual page 528

Page 528 of 630
553-3001-368 Standard 26.00
Appendix E: IP Phone diagnostic utilities
Ethernet statistics
In Local or Remote Mode, the system administrator can view ethernet
statistics (for example, number of collisions, VLAN ID, speed and duplex)
for the IP Phone on a particular endpoint. The exact statistics will depend on
what is available from the IP Phone for the specific endpoint. The user may
select either the Network Port (NIport) or PC port (PCport).
IP Networking statistics
In Local or Remote Mode, the system administrator can view information on
the packets sent, packets received, broadcast packets received, multicast
packets received, incoming packets discarded, and outgoing packets
discarded.
DHCP information process
In Remote Mode, the system administrator can view DHCP settings (for
example, IP address, S1, S2, and S4 addresses) for each IP Phone. In Local
Mode partial information is available.
UNIStim/RUDP statistics
In Remote Mode, the system administrator can view RUDP statistics (for
example, number of messages sent, received, retries, resets, and uptime) for
the IP Phones.
RTP/RTCP statistics
In Remote Mode, the system administrator can view RTP/RTCP QoS metrics
(for example, packet loss and jitter) while a call is in progress.
Network QoS Process
In Remote Mode, the system administrator can view QoS statistics (for
example, packets sent, packets received, packet loss, jitter average and jitter
maximum, and round trip delay).
Supplicant Status
The system administrator uses this option to determine whether 802.1x is
enabled or disabled 802.1x.
August 2007