Nortel 1110 Installation And Operation Manual page 145

PSK SRTP? (0-No, 1-Yes)
GARP Ignore? (0-No,1-Yes)
Note: You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware. For CS 1000
Release 4.5, accept the default value of 0.0.0.0. For Succession Release
3.0 or CS 1000 Release 4.0, enter the TFTP Server IP address. The
IP Phone searches for the TFTP Server for firmware upgrade. If the file
name specified in configuration file is not the same as the current
firmware, the IP Phone downloads the file and upgrades the firmware.
This takes several minutes. When the upgrade is complete, the IP Phone
reboots. For further information about TFTP Server configuration, see
Appendix Appendix H:: "TFTP Server" on
The IP Phone 2002 can support a primary (S1) and secondary (S2)
connect server. If you require IP Phones to register on multiple nodes, see
"Enhanced Redundancy for IP Line Nodes" in IP Line: Description,
Installation, and Operation (553-3001-365).
The IP Phone 2002 searches for the connect server. When the
connection is complete, proceed to step 7.
7 Enter the following information:
Screen prompt
Password
Node
TN
The IP Phone 2002 registers with the TPS and, if needed, begins the
firmware download. This takes several minutes. When complete, the
IP Phone 2002 resets.
Note: The Enhanced UNIStim Firmware Download feature for IP Phones
provides an improved method of delivering new firmware to IP Phones.
For further information on Enhanced UNIStim Firmware Download, see
IP Line: Description, Installation, and Operation (553-3001-365).
Nortel IP Phone 2002
Default 0 (for No)
Default 0 (for No)
Description
IP Phone Installer Password
You are not prompted to enter the IP Phone
Installer Password if it has not been configured in
your Call Server.
the node ID
the TN or VTN
IP Phones Description, Installation, and Operation
Page 145 of 630
page 605.