Removing An Ip Phone 1110 From Service - Nortel 1110 Installation And Operation Manual

Page 344 of 630
Replacing an IP Phone 1110

Removing an IP Phone 1110 from service

553-3001-368 Standard 26.00
Nortel IP Phone 1110
Two IP Phones cannot share the same TN. You must remove the
IP Phone 1110 that is currently using the TN.
Procedure 63
Replacing an IP Phone 1110
1 Obtain the node and TN information of the phone you want to replace.
2 Disconnect the IP Phone 1110 that you want to replace.
3 Follow Procedure 57 on
Procedure 59 on
4 Enter the same TN and Node Number as the IP Phone 1110 you
replaced. The Call Server associates the new IP Phone 1110 with the
existing TN.
Procedure 64
Removing an IP Phone 1110 from service
1 Disconnect the IP Phone 1110 from the network or turn off the power.
Note: The service to the PC is disconnected as well if the PC is
connected to the IP Phone 1110.
If the IP Phone 1110 was automatically configured, the DHCP lease
expires and the IP address returns to the available pool.
2 In LD 11, enter OUT at the TN prompt.
August 2007
IMPORTANT!
page 319 and Procedure 58 on
page 334 to install and configure the IP Phone 1110.
End of Procedure
End of Procedure
page 327, or