Nortel 1110 Installation And Operation Manual page 304

Page 304 of 630
Introduction
Description
553-3001-368 Standard 26.00
Nortel IP Phone 1110
This section explains how to install and maintain the IP Phone1110. For
information on using the IP Phone 1110, see the IP Phone 1110 User Guide.
This section contains the following procedures:
• Procedure 57, "Configuring the IP Phone 1110" on page 319.
• Procedure 58, "Installing the IP Phone 1110 for the first time using
manual configuration" on page 327.
• Procedure 59, "Installing an IP Phone 1110 for the first time using
DHCP" on page 334".
• Procedure 60, "Enabling Full Duplex" on page 341.
• Procedure 61, "Checking Ethernet Statistics" on page 341.
• Procedure 62, "Changing the TN of an existing IP Phone 1110" on
page 343.
• Procedure 63, "Replacing an IP Phone 1110" on page 344.
• Procedure 64, "Removing an IP Phone 1110 from service" on page 344.
Note: After an IP Phone has been installed and configured, if power to
the phone is interrupted, re-entry of the IP parameters, Node Number,
TN, or re-acquisition of firmware is not required.
The IP Phone 1110 uses the customer IP data network to communicate with
the Communication Server 1000. The IP Phone 1110 translates voice into
data packets for transport using Internet Protocol. A Dynamic Host
Configuration Protocol (DHCP) server can be used to provide information
that enables the IP Phone 1110 network connection, and connection to the
Communication Server 1000.
Figure 24 on page 305
August 2007
shows the IP Phone 1110.