Procedure 11; Installing An Ip Phone 2004 For The First Time Using Dhcp - Nortel 1110 Installation And Operation Manual

Page 100 of 630
553-3001-368 Standard 26.00
Nortel IP Phone 2004

Procedure 11

Installing an IP Phone 2004 for the first time
using DHCP
Timing information
There are only four seconds (s) between plugging in the IP Phone 2004
power transformer and the appearance of the Nortel logo in the middle
of the display. When you see the logo, you have one s to respond by
pressing the four soft keys at the bottom of the display in sequence from
left to right, one at a time. If you miss the one-s response time, the IP
Phone 2004 attempts to locate the connect server. You can begin the
power-up sequence again, or you can double-press the Services key to
open the network diagnostic utilities to access the IP Phone settings.
See Appendix Appendix E:: "IP Phone diagnostic utilities" on
To edit network configuration the following soft keys are available:
• OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
• BkSpace—backspace a configuration entry to change it
• Clear—clear an entire configuration entry
• Cancel—cancels out of network configuration. The IP Phone reboots
without saving changes.
1 When the Nortel logo appears in the middle of the display, immediately
press the four feature keys at the bottom of the display in sequence from
left to right.
2 At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network
infrastructure supports 802.1x port-based network access control. Enter
DeviceID and Password.
Note: If you select No, you will not be prompted to enter Device ID and
Password.
For more information on EAP, see Appendix Appendix C:: "802.1x Port-
based network access control" on
August 2007
IMPORTANT!
page 521.
page 525.