Nortel 1110 Installation And Operation Manual page 291

Nortel IP Audio Conference Phone 2033
7 (Optional) Customize the soft keys as required. For more information, see
Software Input/Output: Administration (553-3001-311) and IP Audio
Conference Phone 2033 User Guide.
Procedure 50
Installing an IP Audio Conference Phone 2033
for the first time using DHCP
You will hear a tone shortly before the IP Phone is ready to start the Nortel
IP Phone application. Once the application has loaded and started, you
will see the Nortel logo and Starting DHCP will appear at the bottom of
the screen.
To edit network configuration the following soft keys are available:
• OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
• BkSpace—backspace a configuration entry to change it
• Clear—clear an entire configuration entry
• Cancel—cancels out of network configuration. The IP Phone reboots
without saving changes.
1 To enter the configuration menu, press the three soft keys at the bottom
of the display in sequence from left to right.
2 At the prompt DHCP Yes/No?, enter 1 (1 for Yes).
By default, Full DHCP is configured on the IP Audio Conference Phone
2033. Depending on the configuration requirements, you can change the
IP Audio Conference Phone 2033 configuration to allow the following
IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the DHCP
server
.
End of Procedure
IP Phones Description, Installation, and Operation
Page 291 of 630