Nortel 1110 Installation And Operation Manual page 328

Page 328 of 630
553-3001-368 Standard 26.00
Nortel IP Phone 1110
To edit network configuration the following soft keys are available:
• OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
• BkSpace—backspace a configuration entry to change it
• Clear—clear an entire configuration entry
• Cancel—cancels out of network configuration. The IP Phone reboots
without saving changes.
1 At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network
infrastructure supports 802.1x port-based network access control. Enter
DeviceID and Password.
If you select 0-No (0 for No), you will not be prompted to enter Device ID
and Password.
For more information about EAP, see Appendix Appendix C:: "802.1x
Port-based network access control" on
2 At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default), or 0-N (0 for
No).
For more information about LLDP, see Appendix Appendix D:: "802.1ab
Link Layer Discovery Protocol" on
3 At the prompt DHCP Yes/No?, enter 0-N (0 for No). You are prompted to
enter all parameters.
By default, Full DHCP is configured on the IP Phone 1110. Depending on
the configuration requirements, you can change the IP Phone 1110
configuration to allow the following IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the DHCP
server
Note: A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information on how to set up DHCP servers for use with the
IP Phones, see Data Networking for Voice over IP (553-3001-160).
August 2007
page 521.
page 523.