Nortel 1110 Installation And Operation Manual page 101

3 At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default), or 0-N (0 for
No).
For more information about LLDP, see Appendix Appendix D:: "802.1ab
Link Layer Discovery Protocol" on
4 At the prompt DHCP Yes/No?, enter 1-Y (1 for Yes).
By default, Full DHCP is configured on the IP Phone 2004. Depending on
the configuration requirements, you can change the IP Phone 2004
configuration to allow the following IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the DHCP
server
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information on how to set up DHCP servers for use with the
IP Phones, see Data Networking for Voice over IP (553-3001-160).
5 At the prompt, Cached IP?, select 0 (0-No, default) to conform to the
DHCP standard and to obtain an IP address from the DHCP server. Only
select 1 (1 for Yes) to force the IP Phone to start with a cached IP address
in the event that the IP Phone cannot connect to the DHCP server and
obtain an IP address.
6 Select Partial or Full DHCP.
a. If you select Full DHCP, then the following parameters are retrieved
from the DHCP server:
— a valid IP Phone 2004 IP address
— a subnet mask
— the default Gateway for the IP Phone 2004 on the LAN segment
to which it is connected
— the S1IP. The primary CS 1000 node IP address of the IP
Phone.
— the S1 Action
Nortel IP Phone 2004
page
IP Phones Description, Installation, and Operation
Page 101 of 630
523.