Nortel 1110 Installation And Operation Manual page 373

Procedure 66
Installing the IP Phone 1120E
Timing information
There are approximately 45 seconds (s) between plugging in the
IP Phone 1120E power adapter and the appearance of the text Nortel.
When you see the text Nortel on the phone, you have one s to respond
by pressing the four soft keys at the bottom of the display in sequence
from left to right, one at a time. If you miss the one-s response time, the
IP Phone 1120E attempts to locate the connect server. You can begin
the power-up sequence again, or you can double-press the Services key
to open the Local diagnostic utilities to access the IP Phone settings.
See Appendix Appendix E:: "IP Phone diagnostic utilities" on
Note: If you are prompted to enter a password when you double-press
the Services key, password protection is enabled. For more information
about password protection, see "Local Tools menu password protection"
on page 359.
1 When the Nortel logo appears in the middle of the display, immediately
press the four soft keys at the bottom of the display in sequence from left
to right. The 3. Network Configuration menu opens.
Note: You can press the Apply&Reset soft key to save the following
settings and to reset the IP Phone. You can press the Exit soft key exit
the menu to exit the menu without saving any changes and return to the
3. Network Configuration menu.
When the 3. Network Configuration menu opens, the Enable 802.1x
(EAP) check box is highlighted.
2 Press the Enter key to toggle this item on and off. A check mark appears
to indicate the item is active.
If 802.1x Authentication is enabled, press the Enter key to start the edit
mode. Use the keypad to fill in the following information:
• Device ID
• Password
• Retype password
Nortel IP Phone 1120E
IMPORTANT!
IP Phones Description, Installation, and Operation
Page 373 of 630
page 525.