Nortel 1110 Installation And Operation Manual page 464

Page 464 of 630
553-3001-368 Standard 26.00
Nortel IP Phone 1150E
For further information about 802.1x Authentication, Appendix Appendix
C:: "802.1x Port-based network access control" on
Note: If you do not enable 802.1x Authentication, you will not be
prompted to enter Device ID and Password.
3 Use the Right navigation key to scroll and highlight Enable 802.1x (LLDP
Enable). check box.
For information about 802.1x Authentication, see Appendix Appendix D::
"802.1ab Link Layer Discovery Protocol" on
4 Use the Right navigation key to scroll and highlight DHCP combo box.
5 Press the Enter key.
6 Press the Down navigation key to open list box.
7 Use the Up/Down navigation keys to scroll and highlight one of the
following DHCP options:
• No—disable DHCP support and enter IP network information
manually.
• Partial—IP network information (IP address, network mask, and
gateway address) are provided by the DHCP server. Enter Server 1
IP address, Server 2 IP address, Port, Action, Retry, and PK
numbers manually.
• Full—IP network information, Server 1 IP address, Server 2 IP
address, and XAS information are provided by the DHCP server. All
items are dimmed to prevent manual entry.
Note: A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information on how to set up DHCP servers for use with the
IP Phones, see Data Networking for Voice over IP (553-3001-160).
8 Press the Enter key.
9 Use the Right navigation key to scroll and highlight SET IP. Press the
Enter key to start the edit mode. Use the dialpad to fill in the information.
Set IP—a valid IP Phone 1150E IP address
10 Use the Right navigation key to scroll and highlight NET MASK. Press
the Enter key to start the edit mode. Use the dialpad to fill in the
information.
August 2007
page 521.
page 523.