Full Duplex Mode - Nortel 1110 Installation And Operation Manual

Page 380 of 630

Full Duplex mode

553-3001-368 Standard 26.00
Nortel IP Phone 1120E
For Succession Release 3.0 or CS 1000 Release 4.0, the IP Phone
1120E searches for the TFTP Server for firmware upgrade. If the file
name specified in 1120e.cfg is not the same as the current firmware, the
IP Phone downloads the file and upgrades the firmware. This takes
several minutes. When the upgrade is complete, the IP Phone 1120E
reboots.
Note: The Enhanced UNIStim firmware download is only supported on
CS 1000 Release 4.5 or later.The Enhanced UNIStim firmware download
feature for IP Phones provides an improved method of delivering new
firmware to IP Phones. For further information on Enhanced UNIStim
Firmware Download, see IP Line: Description, Installation, and Operation
(553-3001-365).
The IP Phone 1120E searches for the connect server. When the
connection is complete, proceed with step 42.
The IP Phone 1120E registers with the Terminal Proxy Server (TPS) and,
if needed, begins the firmware download. This takes several minutes.
When download is complete, the IP Phone 1120E resets.
The current Call Server date and time appear on the top line of the display
when the configuration is complete. Self-labeling keys also appear.
42 Check for dial tone and the correct DN on the display.
43 (Optional) Customize the feature keys as required. For more information,
see IP Phone 1120E User Guide (NN43112-103).
In the Configuration menu, Auto Negotiate mode is the default setting for
initial startup. Typically, the IP Phone is connected to a network that supports
Auto Negotiate, and it selects the best speed and duplex mode available.
There is no intervention required under normal operation.
August 2007
End of Procedure