Page 280 of 630
Installation and Configuration
Before you begin
First-time installation
553-3001-368
Standard 26.00
Nortel IP Audio Conference Phone 2033
The following sections provide a step-by-step guide through the IP Audio
Conference Phone 2033 installation and configuration process:
•
Before you begin
•
First-time installation
•
Configuring the IP Audio Conference Phone 2033
•
Startup sequence
•
Installing the IP Audio Conference Phone 2033
Before installing the IP Audio Conference Phone 2033, complete the
following pre-installation checklist:
•
Ensure there is one IP Audio Conference Phone 2033 boxed package for
each IP Audio Conference Phone 2033 being installed. See Table 30,
"Components list for US, CA, CALA, AP, and GC," on page 277 or
Table 31, "Components list for EMEA," on page 278 for a list of
package contents.
•
Ensure the host Call Server is equipped with the Voice Gateway Media
Card, or a Signaling Server with the Line TPS application.
•
If an AC power adapter is required, ensure the correct AC power
transformer is used. The voltage rating of the transformer must match the
wall outlet voltage. See Table 30, "Components list for US, CA, CALA,
AP, and GC," on page 277 or Table 31, "Components list for EMEA,"
on page 278.
You must first install an IP Telephony Node with the Communication Server.
For information about installing an IP Telephony Node, see Signaling Server:
August 2007