Nortel 1110 Installation And Operation Manual page 295

Nortel IP Audio Conference Phone 2033
Cfg XAS? (0-No,1-Yes)
EAP Enable?(0-No, 1-Yes)
Cfg PK (0-No, 1-Yes):0
Duplex (0-Auto, 1-Full)
Note: You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware. For CS 1000
Release 4.5, accept the default value of 0.0.0.0. For Succession Release
3.0 or CS 1000 Release 4.0, enter the TFTP Server IP address. The
IP Phone searches for the TFTP Server for firmware upgrade. If the file
name specified in configuration file is not the same as the current
firmware, the IP Phone downloads the file and upgrades the firmware.
This takes several minutes. When the upgrade is complete, the IP Phone
reboots. For further information about TFTP Server configuration, see
Appendix Appendix H:: "TFTP Server" on
VLANFILTER (0-No, 1-Yes)
Default 0 (for No)
You are not prompted for VLANFILTER if
VLAN is not enabled.
Enter 0 (for No), since External
Application Server is not supported on
the IP Audio Conference Phone 2033.
This prompt exists to support future
implementation of External Application
Server.
Default 0 (for No)
You are not prompted to enter Device ID
and Password if you select 1 for Yes.
For more information on EAP, see
Appendix Appendix C:: "802.1x Port-
based network access control" on
page 521.
Default 0 (for No)
Default 0 (for Auto)
IP Phones Description, Installation, and Operation
Page 295 of 630
page 605.