Nortel 1110 Installation And Operation Manual page 593

Appendix G: Bluetooth wireless technology
setting is Auto. When the setting is Auto, the setting received from the TFTP
Device Config file controls whether Bluetooth wireless technology is
enabled.
When the Bluetooth wireless technology setting is Yes or No, the value
received from the TFTP Device Config file is saved but is not used. The
Bluetooth wireless technology administration setting is forced enabled, or
disabled respectively regardless of the value received in the TFTP Device
Config file. If the setting is then changed back to Auto, the saved value will
take effect if no further setting is received through the TFTP server.
Procedure 124
Configure the Bluetooth wireless technology
administration setting
1 Double-press the Services key.
2 Press 3 on the dialpad to access the Network Configuration menu or
use the Up/Down navigation keys to scroll and highlight the Network
Configuration option.
3 Use the Right navigation key to navigate to the Enable Bluetooth combo
box. The current setting is displayed.
4 Press Enter to start the edit mode.
5 Use the Down navigation key to open the list.
6 Use the Up/Down navigation keys to scroll and highlight the desired
Bluetooth wireless technology mode.
7 Press Enter to select the mode and to close the list.
8 Press Enter to exit the edit mode.
9 Press the Apply&Reset soft key to save the change and to restart the
phone.
The new mode takes affect when the IP Phone restarts. If the administrative
control enabled Bluetooth wireless technology on the phone, the item 3.
Bluetooth Setup appears in 1. Preferences submenu.
End of Procedure
IP Phones Description, Installation, and Operation
Page 593 of 630