Nortel Ip Phone 2002; Introduction; Description - Nortel 1110 Installation And Operation Manual

Page 114 of 630

Introduction

Description

553-3001-368 Standard 26.00

Nortel IP Phone 2002

This section explains how to install and maintain the IP Phone 2002. For
information on using the IP Phone 2002, see the IP Phone 2002 User Guide.
This section contains the following procedures:
• Procedure 17, "Configuring the IP Phone 2002" on page 128.
• Procedure 18, "Installing the IP Phone 2002 for the first time using
manual configuration" on page 132.
• Procedure 19, "Installing an IP Phone 2002 for the first time using
DHCP" on page 139.
• Procedure 20, "Enabling Full Duplex mode" on page 146.
• Procedure 21, "Checking Ethernet Statistics" on page 147.
• Procedure 22, "Changing the TN of an existing IP Phone 2002" on
page 148.
• Procedure 23, "Replacing an IP Phone 2002" on page 149.
• Procedure 24, "Removing an IP Phone 2002 from service" on page 150.
Note: After an IP Phone has been installed and configured, if power is
to the phone is interrupted, re-entry of the IP parameters, Node Number,
TN, or re-acquisition of firmware is not required.
The IP Phone 2002 uses the customer IP data network to communicate with
the Communication Server 1000. The IP Phone 2002 translates voice into
data packets for transport using Internet Protocol. A Dynamic Host
Configuration Protocol (DHCP) server can be used to provide information
that enables the IP Phone 2002 network connection, and connection to the
Communication Server 1000.
Figure 7 on page 115
August 2007
shows the IP Phone.