Nortel 1110 Installation And Operation Manual page 482

Page 482 of 630
LD 11 - Configure the Expansion Module for IP Phones 1100 Series (Part 2 of 2)
Prompt
KEY <key>
KEMOFST
KEY <key>
Installation
553-3001-368 Standard 26.00
Expansion Module for IP Phone 1100 series
Response
<keys conf data>/
<CR>
<KEM> <Key-Off-
set> / <CR>
<keys conf data>/
<CR>
The Expansion Module mounts on the right side of the IP Phone. The
Expansion Module snaps into the receptacle on the back of the IP Phone using
the desk-mount bracket and structural baseplate supplied with the Expansion
Module.
The Expansion Module connects to the IP Phone using the Accessory
Expansion Module (AEM) port on the IP Phone.
Use Procedure 86 to connect the Expansion Module to the IP Phone.
August 2007
Description
<key> is the key number for the Page + Key Offset
entered at PAGEOFST. Enter the key's configuration
<CR> or just <CR>.
KEMOFST is prompted if two or three Expansion
Modules are specified at the KEM prompt and <CR>
is entered for KEY prompt.
This prompt enables you to enter a KEM number of
1, 2, or 3 and a KEY Offset number from 0 to 17.
Once entered, the KEY prompt is prompted with the
appropriate KEY value filled in. <CR> ends the input.
<key> is the key number for the KEM + Key Offset
entered at KEYOFST. Enter the key's configuration
<CR> or just <CR>.