Nortel 1110 Installation And Operation Manual page 594

Page 594 of 630
TFTP configuration
553-3001-368 Standard 26.00
Appendix G: Bluetooth wireless technology
After setting administrative control, it is recommended that the Partial Menu
Lock feature be activated to prevent users from changing the administration
setting. For further information about the Partial Menu Lock feature, see
Appendix Appendix F:: "Configuring the Local Tools menu" on
Use Procedure 125 on
the IP Phone. The IP Phone 1140E is used as an example.
Procedure 125
Enabling Bluetooth wireless technology
on the IP Phone 1140E
Note: If the TFTP server is configured and is running, skip to step 5 on
page 596 to configure the IP Phone 1140E with the TFTP Server IP
address.
1 Add the [DEVICE_CONFIG] section to the 1140e.cfg file.
2 Create the device configuration file. This file must have the same name
as that specified for the FILENAME parameter in the [DEVICE_CONFIG]
section of the 1140e.cfg file. See Figure 71.
Figure 71
Sample of the 1140eDEV.cfg file
ENABLE_BT 1
3 The device configuration file (1140eDEV.cfg) enables Bluetooth wireless
technology if ENABLE_BT 1 is present. If ENABLE_BT 0 is present,
Bluetooth wireless technology is disabled. Figure 72 shows an example
of the 1140e.cfg file with the FW and the ENABLE_BT line.
It is also possible to use the 1140e.cfg file with only the
[DEVICE_CONFIG] section for the control of Bluetooth wireless
technology. Figure 73 on
file with only the [DEVICE_CONFIG] section.
Note: If only the [DEVICE_CONFIG] version is used, you must add the
[FW] section before the BootC FW recovery is used. Otherwise, the
BootC FW download fails and the IP Phone reverts to the BootC TPS
download screen.
August 2007
page 594 to enable Bluetooth wireless technology on
page 595 shows an example of the 1140e.cfg
page 579.