Nortel 1110 Installation And Operation Manual page 483

Expansion Module for IP Phone 1100 series
Procedure 86
Connecting the Expansion Module for
IP Phones 1100 Series to the IP Phone
Damage to Equipment
To avoid damaging the equipment, remove the power
(PoE cable, or local power) from the IP Phone before
connecting the Expansion Module.
CAUTION
The Expansion Module is shipped with the base locked in
position. To avoid damaging the Expansion Module, press
the wall-mount lever, located on the base at the front of
the Expansion Module.
1 Press the wall-mount lever to adjust the stand angle on the IP Phone. See
Figure 50. You can adjust the stand angle to maximum, instead of
removing the stand. See Figure 51 on
Figure 50
Wall-mount lever
page
IP Phones Description, Installation, and Operation
Page 483 of 630
484.
Wall-mount lever