Nortel 1110 Installation And Operation Manual page 57

3 At the prompt DHCP Yes/No?, enter 0-N (0 for No). You are prompted to
enter all parameters.
By default, Full DHCP is configured on the IP Phone 2001. Depending on
the configuration requirements, you can change the IP Phone 2001
configuration to allow the following IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the DHCP
server
Note: A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information on how to set up DHCP servers for use with the
IP Phones, see Data Networking for Voice over IP (553-3001-160).
4 Enter the following information:
Screen prompt
set IP
net msk
def gw
Nortel IP Phone 2001
Description
A valid IP Phone 2001 IP address.
A subnet mask.
The default Gateway for the IP Phone 2001 on the
LAN segment to which the IP Phone 2001 is
connected.
IP Phones Description, Installation, and Operation
Page 57 of 630