Honda Acura NSX 1991 Service Manual page 72

After the engine is in place:
l Torque the engine mounting bolts in sequence
shown below.
CAUTION: Failure to tighten the bolts in the proper
sequence can cause excessive noise and vibration
and reduce bushing life; check that the bushings
are not twisted or offset.
l
Bleed air from the cooling system (See Section IO)
l
Bleed air from the brake lines (See Section 19)
Adjust the throttle cable tension.
Check the clutch pedal free play.
disassembling clutch (See
mm
60 N-m 16.0 kg-m. 43 lb-ft)
TRANSMISSION
MOUNT (A/T)
95 Nom (9.5 kg-m.
l b - f t ) ,
69
MOUNT (A/T)
NUT
77 N-m 17 7 kn-m
56 lb-ft)
Replace.
Section 12).
SPECIAL BOLT
77 Nom (7.7 kg-m,
56 lb-ft)
Re lace.
a12 x 1.25 mm
mm
smoothly (M/T See Section 13, A/T See Section
Adjust the alternator belt (See Section 23).
Adjust the A/C belt (See Section 22).
Clean battery posts and cable terminals with sand-
paper, assemble, then apply grease to prevent
corrosion.
Inspect for fuel leakage:
After assembling fuel line parts, turn on the igni-
l
tion switch (do not operate the starter) so that
the fuel pump is operated for approximately two
seconds and the fuel is pressurized. Repeat this
operation two or three times and check whether
any fuel leakage has occurred at any point in the
fuel line.
60 Nom 16.0 ka-m A
BOLT/NUT
shifts into gear
RUBBER CAP