Honda Acura NSX 1991 Service Manual page 20

After any degree of frontal body damage, inspect
both dash sensors.
Replace a sensor if there are any signs of deuts,
cracks or deformation.
2. Be sure the sensors are installed securely.
BRACKET
CAUTION: Take extra care when painting or doing
body work on any part of the dashboard lower
panel. Avoid direct exposure of the sensors or wir-
ing to heat guns, welding or spraying equipment.
tery cables.
l Install the short connector before performing
work on the dashboard lower panel or the SRS
sensors.
DASH BOARD
LOWER PANEL
SENSOR
Never attempt to modify, splice or repair SRS
1 .
wiring.
NOTE: SRS wiring can be identified by special
yellow outer protective
Be sure to install the harness wires so that they are
2.
not pinched or interfering with other car parts.
3. Make sure all SRS ground locations are clean and
grounds are securely fastened for optimum metal-
to-metal contact. Poor grounding can cause inter-
mittent problems that are difficult to diagnose.
covering.
1-19