Honda Acura NSX 1991 Service Manual page 64

15. Remove the intake manifold plate and the top
cover.
16. Remove the throttle cable by loosening the locknut,
then slip the cable end out of the throttle bracket
and accelerator linkage.
NOTE:
it. Always replace a kinked cable with a new
one.
Section 1 I).
INTAKE MANIFOLD
TOP
17. Relieve fuel pressure by slowly loosening the ser-
vice bolt on the fuel filter abo'ut one turn (See Sec-
tion 11).
fuel system. Keep open flame away from work
area. Drain fuel only into an approved container.
CAUTION:
l
Before disconnecting any fuel line, the fuel
pressure should be relieved as described above.
l Place a shop towel over the fuel filter to Prevent
pressurized fuel from spraying over the en,gine.
12 Nom (1.2 kg-m, 9 lb-ft)
THROTTLE CABLE
ADJUSTING NUT
18. Remove the fuel feed pipe.
19. Remove the fuel return hose from the pressure con-
trol valve.
22 Nom (2.2 kg-m, 16 lb-ft)
FUEL FEED
\ PIPE
Replace.
20. Disconnect two hoses, then remove the expansion
tank.
EXPANSION TANK
WATER iiOSES
6 x l.Omm
12 N*m (1.2 kg-m, 9 lb-ft)
\
FUEL RETURN
HOSE
6x l.Omm
10 N-m (1 .O kg-m, 7 lb-ft)
(cont'd)