Honda Acura NSX 1991 Service Manual page 19

Precautions/Procedures
Steering Wheel and Cable Reel Alignment:
NOTE: To avoid misalignment of the steering
wheel or airbag on reassembly, make sure the
wheels are turned straight ahead before removing
the steering wheel.
Rotate the cable reel clockwise until it stops.
Then rotate it counterclockwise (approximately
two turns) until:
l
The yellow gear tooth lines up with the mark on
the cover.
l The arrow on the cable reel label points straight
ALIGNMENT MARK
ARROW
MARK
YELLOW GEAR TOOTH
2. Steering Column Removal:
CAUTION:
disconnect the connector between the cable
reel and the main SRS harness.
without dismounting the steering wheel, lock
the steering by turning the ignition key to
O-LOCK position or remove the key from the ig-
nition so that the steering wheel will not turn
round.
S R S
3. Steering wheel:
Do not replace the original steering wheel with any
other design, since it will make it impossible to pro-
perly install the airbag (Only use genuine HONDA
replacement parts).
4. After reassembly confirm that the wheels are still
straight ahead and that steering wheel spoke angle
is correct. If minor spoke angle adjustment is
necessary, do so only by adjustment of the tie rods,
not by removing and repositioning the steering
wheel.