Precautions/Procedures - Honda Acura NSX 1991 Service Manual

Precautions/Procedures

1 . Carefully inspect any SRS part before installing.
Do not install any part that shows signs of being
dropped or improperly handled, such as dents,
cracks or deformation:
2. Use only the digital multimeter (KS-AHM-
circuit tester, it may cause an accidental deploy-
ment and possible injury.
3. Do not install used SRS parts from another car.
When repairing, use only new SRS parts.
4. Except when performing electrical inspections,
always disconnect both the negative cable and
positive cable at the battery before begining work.
Replacement of the lighting and wiper combination
5.
switches and cruise control switch can be done
without removing the steering wheel:
ment, see section 23.
23.
Do not try to disassemble the airbag assembly. There
are not separately serviceable parts. Once an airbag has
been operated (deployed), it cannot be repaired or
reused.
SHORT CONNECTOR (RED)
For temporary storage of the airbag assembly during
service, please observe the
1 . Store the removed airbag assembly with the pad
surface up.
If the airbag is improperly stored face
down, accidental deployment could propel the unit
with enough' force to cause serious injury.
2. Store the removed airbag assembly on a secure flat
surface away from any high heat source (ex-
ceeding 1 OO°C/21
detergent or water.
CAUTION: Improper handling or storage can inter-
nally damage the airbag assembly, making it
inoperative.
If you suspect the airbag assembly has been
damaged, install a new unit and refer to the Deploy-
ment/Disposal Procedures for scrapping of the
damaged airbag.
following precautions: