Tacacs+ Group Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
TACACS+ G
ROUP
To activate the Terminal Access Controller Access Control System Plus (TACACS+) Group
Configuration mode, enter the aaa group server tacacs+ command at the Global Configuration mode
prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#aaa group server tacacs+ TEST GROUP
ProCurve(config-sg-tacacs+)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
All other commands for this command set are described in this section in alphabetical order.
server <host> on page 1428
5991-2114
C
ONFIGURATION
© Copyright 2007 Hewlett-Packard Development Company, L.P.

TACACS+ Group Configuration Command Set

C S
OMMAND ET
1427