Requirements For Connecting Programming Terminal; Connecting Rs-232C Cable; Communication Parameters - Panasonic KX-TVS100 Quick Installation Manual

To use D-PITS Integration, Port 1 of the VPS must be connected to the lowest number jack assigned as a
VPS extension. When D-PITS Integration is activated, a single extension jack provides two single-line
interfaces to the CO card on the VPS. For example, only connect one line cord (4 wire) to Port 1 on the
VPS. This will provide two extensions. Then connect the second line cord (4 wire) to Port 3 (if installed)
for the other two extensions. Only one D-PITS (4 wire) extension can be connected per card.
3. Connect the PBX extension to the CO ports of the Voice Processing System.
Follow instructions on the PBX to connect the PBX extension ports to the CO ports on the VPS. Use a
four-conductor wiring cord for connection with KX-TD systems that use D-PITS integration. Use a two-
conductor wiring cord for connections to all other PBXs. The maximum length of the wire varies
according to the PBX length. (Refer to the PBX installation manual for length.) Write down the extension
port number of the PBX extensions that are connected to the TVS100. You will need to know these
numbers when accessing the TVS100.
4. Close the front cover of the VPS (and the PBX if the cover was removed).
5. Tighten the two screws firmly.
R
EQUIREMENTS FOR
The programming terminal must be connected with a serial cable with an RS-232C connector at the EIA port.
This enables system administration (system set-up, mailbox set-up, and system diagnosis). If the DEC VT220
(100) or VT220 (100) compatible terminal is used, the system administrator can set up system parameters and
diagnose the system with the menu-driven program. Other RS-232C ASCII terminals can also be used, but we
recommend a terminal that supports VT emulation. The wiring and parameters are the same for either terminal
type.
Communication parameters of the VPS have been set to the following values at the factory:
C RS-232C C
ONNECTING
Your PBX
C P
ONNECTING ROGRAMMING

COMMUNICATION PARAMETERS

Baud Rate:
Word Bit Length:
Parity:
Stop Bit Length:
ABLE
VPS
T
ERMINAL
9600 bps
8 Bits
None
1 Bit
6.18