Switchport Promiscuous-Mode - Cisco MDS 9000 series Command Reference Manual

switchport promiscuous-mode

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switchport promiscuous-mode
To configure the promiscuous-mode in Gigabit Ethernet interfaces, use the switchport
promiscuous-mode command in interface configuration submode. Use the no form of the command to
delete the configured switch port information.
Syntax Description off
on
Defaults Disabled
Command Modes
Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines Access this command from the
Examples The following example enables promiscuous mode on a Gigabit Ethernet interface.
switch# config terminal
switch(config)# interface gigabitethernet 8/1
switch(config-if)# switchport promiscuous-mode on
The following example disables promiscuous mode on a Gigabit Ethernet interface.
switch(config-if)# switchport promiscuous-mode off
The following example disables promiscuous mode on a Gigabit Ethernet interface.
switch(config-if)# no switchport promiscuous-mode
Related Commands Command
show interface
gigabitethernet
Cisco MDS 9000 Family Command Reference
21-74
switchport promiscuous-mode {off | on}
no switchport promiscuous-mode
Disables promiscuous mode.
Enables promiscuous mode.
Modification
This command was introduced.
Description
Displays an interface configuration for a specified Gigabit Ethernet
interface.
submode for Gigabit Ethernet interfaces.
switch(config-if)#
Chapter 21 S Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x