System Settings; Console Settings (Autobaud Rate Support) - Cisco SX350 Series Administration Manual

Administration

System Settings

System Settings
STEP 1
STEP 2
STEP 3

Console Settings (Autobaud Rate Support)

Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
To enter system settings:
Click Administration > System Settings.
View or modify the system settings.
• System Description—Displays a description of the device.
• System Location—Enter the physical location of the device.
• System Contact—Enter the name of a contact person.
• Host Name—Select the host name of this device. This is used in the prompt of CLI
commands:
- Use Default—The default hostname (System Name) of these switches is:
switch123456, where 123456 represents the last three bytes of the device MAC
address in hex format.
- User Defined—Enter the hostname. Use only letters, digits, and hyphens. Host
names cannot begin or end with a hyphen. No other symbols, punctuation
characters, or blank spaces are permitted (as specified in RFC1033, 1034, 1035).
• Custom Banner Settings—The following banners can be set:
- Login Banner—Enter text to display on the Login page before login. Click Preview
to view the results.
- Welcome Banner—Enter text to display on the Login page after login. Click
Preview to view the results.
When you define a login banner from the web-based configuration utility, it also
NOTE
activates the banner for the CLI interfaces (Console, Telnet, and SSH).
Click Apply to save the values in the Running Configuration file.
The console port speed can be set to one of the following speeds: 4800, 9600, 19200, 38400,
57600, and 115200 or to Auto Detection.
5
64