Dell PowerConnect 6224 Command Line Interface Manual page 104

Command
auto-cost
bandwidth
capability opaque
clear ip ospf
default-information
originate
default-metric
distance ospf
distribute-list out
enable
exit-overflow-interval
external-lsdb-limit
ip ospf area
ip ospf authentication
ip ospf cost
ip ospf dead-interval
ip ospf hello-interval
ip ospf mtu-ignore
ip ospf network
104
Command Groups
Description
Allows user to change the reference bandwidth
used in computing link cost.
Allows user to change the bandwidth used in
computing link cost.
Enables Opaque Capability on the router.
Resets specific OSPF states.
Controls the advertisement of default routes.
Sets a default for the metric of distributed routes. ROSPF
Sets the route preference value of OSPF in the
router.
Specifies the access list to filter routes received
from the source protocol.
Resets the default administrative mode of OSPF
in the router (active).
Configures the exit overflow interval for OSPF.
Configures the external LSDB limit for OSPF.
Enables OSPFv2 and sets the area ID of an
interface.
Sets the OSPF Authentication Type and Key for
the specified interface.
Configures the cost on an OSPF interface.
Sets the OSPF dead interval for the specified
interface.
Sets the OSPF hello interval for the specified
interface.
Disables OSPF maximum transmission unit
(MTU) mismatch detection.
Configure OSPF to treat an interface as a point-
to-point
rather than broadcast interface.
Mode*
ROSPF
IC
RC
PE
ROSPF
ROSPF
ROSPF
ROSPF
ROSPF
ROSPF
IC
IC
IC
IC
IC
IC
IC