Dell PowerConnect 6224 Command Line Interface Manual page 105

Command
ip ospf priority
ip ospf retransmit-
interval
ip ospf transmit-delay
maximum-paths
nsf
nsf helper
nsf helper strict-lsa-
checking
nsf restart-interval
network area
passive-interface
passive-interface default Enables the global passive mode by default for all
passive-interface (router
mode)
redistribute
router-id
router ospf
show ip ospf
Description
Sets the OSPF priority for the specified router
interface.
Sets the OSPF retransmit Interval for the
specified interface.
Sets the OSPF Transit Delay for the specified
interface.
Sets the number of paths that OSPF can report
for a given destination.
Enables OSPF graceful restart.
Allow OSPF to act as a helpful neighbor for a
restarting router.
Set an OSPF helpful neighbor exit helper mode
whenever a topology change occurs.
Configures the length of the grace period on the
restarting router.
Enables OSPFv2 on an interface and sets its area
ID if the IP address of an interface is covered by
this network command.
Sets the interface or tunnel as passive.
interfaces.
Sets the interface or tunnel as passive.
Configures OSPF protocol to allow redistribution
of routes from the specified source
protocol/routers.
Sets a 4-digit dotted-decimal number uniquely
identifying the router OSPF ID.
Enters Router OSPF mode.
Displays information relevant to the OSPF
router.
Command Groups
Mode*
IC
IC
IC
ROSPF
ROSPF
ROSPF
ROSPF
ROSPF
ROSPF
IC
ROSPF
ROSPF
ROSPF
ROSPF
GC
PE
105