Dell PowerConnect 6224 Command Line Interface Manual page 163

Please enter the user name. [root]:root
Please enter the user password:
Please reenter the user password:
Step 3:
Next, an IP address is setup. The IP address is
defined on the default VLAN (VLAN #1), of which all
ports are members. This is the IP address you use to
access the CLI, Web interface, or SNMP interface for
the switch. Optionally you may request that the system
automatically retrieve an IP address from the network
via DHCP (this requires that you have a DHCP server
running on the network).
To setup an IP address:
Please enter the IP address of the device (A.B.C.D) or
enter "DHCP" (without the quotes) to automatically
request an IP address from the network DHCP server.
[192.168.2.1]:
Please enter the IP subnet mask (A.B.C.D or /nn).
[255.255.255.0]:
Step 4:
Finally, setup the default gateway. Please enter the
IP address of the gateway from which this network is
reachable. [0.0.0.0]:
This is the configuration information that has been
collected:
User Account setup = root
Password = ********
Management IP address = 192.168.2.1 255.255.255.0
Default Gateway = 0.0.0.0
Operation Mode = Normal
Step 5:
163
Using the CLI