Tunnel Mode Ipv6Ip - Dell Networking 2024 Reference Manual

Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies the destination transport address of tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel destination 10.1.1.1

tunnel mode ipv6ip

Use the tunnel mode ipv6ip command in Interface Configuration mode to
specify the mode of the tunnel.
Syntax
tunnel mode ipv6ip [6to4]
no tunnel mode
• 6to4 — Sets the tunnel mode to automatic.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies ipv6ip mode for tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel mode ipv6ip
console(config-if-tunnel1)#tunnel mode ipv6ip 6to4
1360
Tunnel Interface Commands