Table of Contents
Advertisement
Media Flow Manager Administrator's Guide
ftp-server
Configure FTP (file transfer protocol) settings.
ftp-server {enable}
Enable the FTP server. Use no ftp-server enable to disable.
show ftp-server
Show FTP server settings.
hostname
Set system hostname. See
hostname <hostname>
Set the system hostname. Use no hostname to clear the setting.
show hosts
Display system hostname, DNS configuration, and static host mappings.
image
Manipulate system software images.
image
boot {location <location_ID> | next}
delete <image_name>
fetch {<URL> | <SCP>} [filename <name>]
install <image_filename>
location <partition_number>
progress {no-track | track}
verify {ignore-sig | require-sig}]
move <source_image_name> <dest_image_name>
options require-sig
Notes:
•
—Specify from which location the image should boot by default; there are only two
boot
locations to choose from so the options are 1 and 2 for location ID. If next is used, set the
boot location to be the next one after the one currently booted from. Note this does not
mean the next one after the one Media Flow Controller is currently set to boot from; thus
the command is idempotent, and does not continue to cycle through all of the available
locations.
•
delete
•
fetch
given that name; otherwise it is given whatever name it had on the server (the part after
the last slash in the URL). See the
URL format).
•
install
"System Config > Hostname" on page 43
—Delete the specified image file.
—Download an image from the specified URL. If a filename is specified, the file is
—Install the specified image file. Arguments:
"Command Arguments Key" on page 95
CHAPTER 5 CLI Commands
for task details.
for the scp
ftp-server
121
Advertisement
Table of Contents
