Table 148: Determining The Service Interim Accounting Interval; Table 149: Sample Acct-Start Message For A Service Session - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

JUNOSe 11.1.x Broadband Access Configuration Guide
When the Service-Interim-Acct-Interval attribute is configured for a service, Service
Manager uses the guidelines shown in Table 148 on page 674 to determine the correct
interim accounting interval to use for the service.

Table 148: Determining the Service Interim Accounting Interval

Table 149 on page 674 describes a sample Acct-Start message for a service session.
In the table, the three fields used by Service Manager are shown in bold characters.
An Acct-Start message for a subscriber session without any active services does not
include the Service-Session attribute.

Table 149: Sample Acct-Start Message for a Service Session

674
Configuring RADIUS Accounting for Service Manager
Service-Interim-Acct-
Interval Value
0
1–599
600–86400
86401 or greater
The tag for the service-interim-acct-
interval attribute does not match the
tag for any service-activate attribute
(VSA 26-65)
RADIUS Attribute
acct-status-type
username
event-timestamp
acct-delay-time
nas-identifier
acct-session-id
nas-ip-address
class
framed-protocol
framed-compression
framed-ip-address
framed-ip-netmask
Service Manager Action
Disables interim accounting for the service
Uses 600
Uses the specified value
Uses 86400
Discards the service-interim-acct-interval attribute
Sample Value
1
client1@isp1.com
1112191723
0
ERX-01-00-06
erx FastEthernet 12/0:0001048580:002478
10.6.128.45
(binary data)
0
0
100.20.0.1
0.0.0.0