Table of Contents
Advertisement
JunosE 11.2.x BGP and MPLS Configuration Guide
Setting the Baseline for MPLS Statistics
Setting a Baseline for MPLS Major Interface Statistics
322
Monitoring MPLS Status and Configuration on page 343
Monitoring MPLS Explicit Paths on page 345
Monitoring the RSVP-TE Bypass Tunnels on page 346
Monitoring MPLS Labels Used for Forwarding on page 347
Monitoring MPLS Interfaces on page 348
Monitoring MPLS Minor Interfaces on page 354
Monitoring MPLS Next Hops on page 355
Monitoring the Configured Mapping between PHB IDs and Traffic Class/Color
Combinations on page 356
Monitoring RSVP-TE Profiles and MPLS Tunnel Profiles on page 357
Monitoring RSVP Path State Control Blocks, Reservation State Control Blocks, or
Sessions on page 358
Monitoring RSVP MD5 Authentication on page 362
Monitoring RSVP-TE Interfaces Where BFD is Enabled on page 362
Monitoring RSVP-TE Interface Counters on page 363
Monitoring RSVP-TE Graceful Restart on page 365
Monitoring RSVP-TE Hello Adjacency Instances on page 366
Monitoring Status and Configuration for MPLS Tunnels on page 368
Verifying and Troubleshooting MPLS Connectivity on page 370
Packet Flow Examples for Verifying MPLS Connectivity on page 372
Troubleshooting MTU Problems in Point-to-Point LSPs on page 379
You can use the baseline mpls commands to set a statistics baseline for MPLS operations.
The router implements the baseline by setting the statistics to zero and then subtracting
this baseline when you retrieve baseline-relative statistics.
Use the delta keyword with the show mpls commands to display baselined statistics.
Tasks to set a baseline for MPLS statistics are:
Setting a Baseline for MPLS Major Interface Statistics on page 322
Enabling and Setting a Baseline for MPLS Forwarding Table Statistics on page 323
Enabling and Setting a Baseline for MPLS Next-Hop Table Statistics on page 323
Setting a Baseline for MPLS Tunnel Statistics on page 324
Enabling Statistics Collection for Policies Attached to MPLS Tunnels on page 324
To set a statistics baseline for MPLS major interfaces:
Issue the baseline mpls interface command for a specific MPLS major interface.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
