Linking The Dial-In Profile With The Device; Setting The Time-Out Period For The Modem Dial-In Authentication; Configuring Border Signaling Gateway Objects - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Linking the Dial-In Profile with the Device

Setting the Time-out Period for the Modem Dial-In Authentication

Configuring Border Signaling Gateway Objects

426
Enter the new phone number.
4.
Click
OK.
5.
From the Device configuration editor:
Select >
Network Interface
1.
Enter the name of the Dial-in profile in the
2.
Click
3. OK.
From the Device configuration editor:
Select >
1. Device Admin
Set the time period in the
2.
Click
3. OK.
The Border Signaling Gateway (BSG) handles VoIP signaling in Junos OS based on policies
you set. NSM allows you to define two shared BSG objects in the Object Manager that
can be referenced in the BSG transaction rulebase in the Policy Manager. You can create,
view, edit, and delete the following BSG objects from the Object Manager.
BSG Service Point object: This a polymorphic object for specifying the egress service
point in a transaction term's route action. With the service point object, you can specify
the device, a gateway in the device, and a service point in the gateway.
BSG Admission Controllers: BSG Admission Controllers control Session Initiation
Protocol (SIP) dialogs and transactions. You can define the following settings for both
dialogs and transactions:
Maximum Concurrent Number
that are allowed. You can set it from 0 to 100,000. Zero causes all calls to be rejected.
The default setting is 100000
Committed Attempts Rate
an out-of-dialog transaction. You can set it from 0 to 100. The default setting is 100
Committed Burst Size
committed-rate and still be accepted. You can set it from 0 to 200.
You can define one admission controller per gateway, and reference all of the admission
controllers from the BSG transaction rulebase in the Policy Manager. Manager.
Admission controller objects are listed on the transaction policy's shared-object menu,
where you can drag and drop them into the transaction terms. When you import a
device, the admission controller objects are also imported.
> >
Edit Serial Interface
Dial-in Name
CLI Management.
Modem Dial-In Authentication Time-out
This is the maximum number of concurrent dialogs
The maximum number of attempts per second to initiate
The maximum number of dialogs allowed to burst above the
Modem.
field.
field.
Copyright © 2010, Juniper Networks, Inc.