Monitoring L2Tp Dial-Out - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

l2tp dial-out session delete
l2tp dial-out session reset
l2tp dial-out target

Monitoring L2TP Dial-Out

To monitor L2TP dial-out, see:
Use to delete a dial-out session.
Closes any L2TP outgoing call associated with the dial-out session.
Example
host1#l2tp dial-out session delete 10.10.0.0
There is no no version.
See l2tp dial-out session delete
Use to force the dial-out session to the dormant state where it remains until the
dormant timer expires or it receives a new trigger.
Closes any L2TP outgoing call associated with the dial-out session.
Example
host1#l2tp dial-out session reset 10.10.0.0
There is no no version.
See l2tp dial-out session reset
Use to define an L2TP dial-out target. When the router receives packets destined
for the target, it creates a dial-out session.
When you create a target, you must specify the following:
ipAddress IP address of the target
ipAddressMask IP address mask of the target
domainName Domain name used in the outgoing call Access-Request
message
profileName Name of profile used to create the interface stack
Example
host1(config)#l2tp dial-out target 10.10.0.0 255.255.0.0 L2TP-dial-out.de.dt
profile dialOut
Use the default version to remove the L2TP dial-out route.
Use the no version to remove the L2TP dial-out route or target.
See l2tp dial-out target
Chapter 14: Configuring L2TP Dial-Out
Monitoring L2TP Dial-Out
415