Garp Commands; Show Private-Group - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

no private-group name
This command is used to remove the specified private group.
Format
private-group name <privategroup-name>
Mode Global Config

show private-group

This command displays the private groups' information.
Format
show private-groupname [<private-group-name>|<private-group-
id>|port <unit/slot/port>]
Mode Priviledged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
The VLAN ID associated with the port
Port VLANID
Private Group Total number of private groups is 192.
ID
Private Group The name string can be up to 24 bytes of non-blank characters
Name
Private Group The mode can be either "isolated" or "community".

GARP Commands

This section describes the commands you use to configure Generic Attribute Registration Protocol
(GARP) and view GARP status. The commands in this section affect both GARP VLAN
Registration Protocol (GVRP) and Garp Multicast Registration Protocol (GMRP). GARP is a
protocol that allows client stations to register with the switch for membership in VLANS (by using
GVMP) or multicast groups (by using GVMP).
Switching Commands
Managed Switch CLI Manual, Release 8.0
.
v1.0, July 2009
3-56