Email Alerting And Mail Server Commands; Logging Email; Logging Email Urgent - NETGEAR ProSafe M7100-24X User Manual

no logging persistent
Use this command to disable the persistent logging in the switch.
Format
no logging persistent
Mode
Global Config

Email Alerting and Mail Server Commands

logging email

This command enables email alerting and sets the lowest severity level for which log
messages are emailed. If you specify a severity level, log messages at or above this severity
level, but below the urgent severity level, are emailed in a non-urgent manner by collecting
them together until the log time expires. You can specify the severitylevel value as either an
integer from 0 to 7 or symbolically through one of the following keywords: emergency (0),
alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
Default
Disabled; when enabled, log messages at or above severity Warning (4) are emailed
Format
logging email [<severitylevel>]
Mode
Global Config
no logging email
This command disables email alerting.
Format
no logging email
Mode
Global Config

logging email urgent

This command sets the lowest severity level at which log messages are emailed immediately
in a single email message. Specify the severitylevel value as either an integer from 0 to 7 or
symbolically through one of the following keywords: emergency (0), alert (1), critical
(2), error (3), warning (4), notice (5), info (6), or debug (7). Specify none to indicate
that log messages are collected and sent in a batch email at a specified interval.
Default
Alert (1) and emergency (0) messages are sent immediately
Format
logging email urgent {<severitylevel> | none }
Mode
Global Config
ProSafe Managed Switch
Utility Commands
534