Poe Usagethreshold; Show Poe Port Info - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

16.1.4 poe usagethreshold

This command sets the power threshold level at which a trap will be generated. If the total
power consumed is greater than or equal to the specified percentage of the total power
available, a trap will be sent. The switch will continue to provide power even if the
threshold is exceeded. The threshold value is for providing a warning. It does not interrupt
the power. Valid values are 0 - 100.
Default
Format
Mode

16.1.5 show poe port info

This command displays a summary for the ports that support the PoE function.
Format
Mode
The following fields are displayed for each port. If a port does not have link, or is not
enabled for PoE, the following fields display a value of "N/A".
16.1.5.1 Class
The Class field reports the class of the powered device according to IEEE802.3af
definition.
Table 16-1. Class of the Powered Device
Class Usage
0 Default
1 Optional
2 Optional
3 Optional
4 Not Allowed
16.1.5.2 Output
The Output field reports the power supplied to the powered device (in watts).
16-4
80
poe usagethreshold <0-100>
Global Config
show poe port <unit/slot/port, All>
Privilege
Max Power
0.44-12.95
0.44-3.84
3.84-6.49
6.49-12.95
Reserved
v4.1, October 2008
Power Over Ethernet Commands