Ip Multicast Commands; Multicast Commands; Ip Multicast; Ip Mcast Boundary - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

15.1 Multicast Commands

This section describes the commands you use to configure IP Multicast and to view IP
Multicast settings and statistics.

15.1.1 ip multicast

This command sets the administrative mode of the IP multicast forwarder in the router to
active. For multicast routing to become operational, IGMP must be currently enabled. An
error message appears if you enable multicast routing while IGMP is disabled. However,
the IP multicast mode configuration is stored in the multicast configuration file and is
automatically enabled once IGMP is enabled.
Default
Format
Mode
15.1.1.1 no ip multicast
This command sets the administrative mode of the IP multicast forwarder in the router to
inactive. For multicast routing to become operational, IGMP must be currently enabled.
An error message will be displayed on the CLI if multicast routing is enabled while IGMP
is disabled. However, the IP multicast mode configuration is stored in the multicast
configuration file and is automatically enabled once IGMP is enabled.
Format
Mode

15.1.2 ip mcast boundary

This command adds an administrative scope multicast boundary specified by
<
groupipaddr
applicable. <
groupipaddr
Format
Mode
15-2
disabled
ip multicast
Global Config
no ip multicast
Global Config
> and < > for which this multicast administrative boundary is
mask
> is a group IP address and <
ip mcast boundary <groupipaddr> <mask>
Interface Config
v1.0, December 2005
> is a group IP mask.
mask

IP Multicast Commands