Dhcp And Bootp Relay Commands; Show Ip Vrrp Interface Brief; Bootpdhcprelay Cidoptmode - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

<1/0/1>
TrackRoute (pfx/len)
------------------------
10.10.10.1/255.255.255.0

show ip vrrp interface brief

This command displays information about each virtual router configured on the switch. This
command takes no options. It displays information about each virtual router.
Format
show ip vrrp interface brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
VRID The router ID of the virtual router.
IP Address The virtual router IP address.
Mode Indicates whether the virtual router is enabled or disabled.
State The state (Master/backup) of the virtual router.

DHCP and BOOTP Relay Commands

This section describes the commands you use to configure BootP/DHCP Relay on the switch. A
DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies between clients
and servers when they are not on the same physical subnet.

bootpdhcprelay cidoptmode

This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default disabled
Format
bootpdhcprelay cidoptmode
Mode Global Config
Routing Commands
down
State DecrementPriority
------ ------------------
down
v1.0, July 2009
Managed Switch CLI Manual, Release 8.0
10
10
4-34